Bearing Housing Repair Kit for Yamaha 222SD 1800 2023

Bearing Housing Repair Kit for Yamaha 222SD 1800

This bearing housing repair kit is built for the Yamaha 222SD 1800 jet boat, restoring worn or noisy bearing housing components so the pump assembly spins true again.

Overview

This bearing housing repair kit for Yamaha 222SD 1800 delivers the components needed to refresh a tired jet pump bearing housing. It keeps the shaft supported and aligned so vibration and noise stay under control. A solid choice for owners handling routine jet drive maintenance themselves.

Built For Performance

• Direct fit for the Yamaha 222SD 1800 bearing housing assembly
• Supports proper shaft alignment inside the housing
• Helps cut driveline vibration and bearing noise
• Suited to fresh water and salt water jet boat use
• Serviceable replacement for worn housing components

Fits These Machines

• for Yamaha 222SD 1800, 2023

On-The-Job Use

• Routine jet pump bearing service
• Rebuilding a housing after water intrusion
• Restoring smooth shaft rotation before the season
• Reducing vibration felt through the hull at speed

Specs At A Glance

Good To Know

Q: Do I need to remove the jet pump to install this kit? A: In most cases the pump assembly comes off first so the housing can be serviced on the bench. Follow your service manual for the exact sequence.

Q: How often should bearing housing components be replaced? A: Replace them when you notice growling, vibration, or water in the housing, or during scheduled jet pump service intervals. Early replacement avoids shaft and impeller damage.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.