Bottom Line 4" Carbides Runners Skags for Arctic Cat fits many 1992-2000 Sleds

Bottom Line 4" Carbides Runners Skags for Arctic Cat

These Bottom Line 4-inch carbide runners skags are designed for Arctic Cat snowmobiles, providing sharp steering and durable wear for models from 1992 to 2000.

Overview

These Bottom Line 4-inch carbide runners skags offer reliable traction and control for Arctic Cat snowmobiles. With a 4-inch carbide edge, they cut through snow and ice for precise handling. This set is a trusted replacement for many 1992-2000 Arctic Cat sleds.

Built For Performance

• 4-inch carbide edge for superior ice and hardpack grip
• Durable steel body resists bending and wear
• Precision-ground carbide for consistent steering
• Easy bolt-on installation using existing hardware
• Designed to fit a wide range of Arctic Cat models

Fits These Machines

• for Arctic Cat snowmobiles (1992-2000)

On-The-Job Use

• Trail riding on icy or hardpack snow
• Off-trail exploration requiring sharp turning
• Replacing worn or dull runners on older sleds
• Preparing sled for winter season riding

Specs At A Glance

Good To Know

Q: Are these runners compatible with all Arctic Cat skis from 1992-2000? A: They are designed to fit many standard Arctic Cat skis of that era, but always verify your ski's mounting pattern and width before purchase.

Q: Do I need to replace both runners at the same time? A: It is recommended to replace both skags to ensure balanced handling and even wear across the front end.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.