Brake Cable for John Deere Cyclone 440 1976-1978
Brake Cable for John Deere Cyclone 440 1976-1978
Couldn't load pickup availability
Brake Cable for John Deere Cyclone 440
This brake cable is a replacement control cable built to connect the brake lever to the brake assembly on the John Deere Cyclone 440 snowmobile.
Overview
This brake cable serves as the direct link between the handlebar lever and the brake mechanism on the John Deere Cyclone 440. A fresh cable restores clean, predictable lever feel when the original has stretched, frayed, or seized. It fits riders maintaining or restoring a vintage John Deere snowmobile.
Built For Performance
- Inner cable designed to slide freely inside the outer housing
- Correct length for the Cyclone 440 chassis and lever position
- Fittings formed to match the lever and brake assembly attachment points
- Outer housing built to resist moisture and abrasion on the trail
- Direct replacement for the original cable routing
Fits These Machines
- for John Deere Cyclone 440, 1976-1978
On-The-Job Use
- Replacing a stretched or frayed original brake cable
- Restoring proper lever travel on a vintage sled
- Routine brake system service before the season
- Vintage snowmobile restoration projects
Specs At A Glance
| Application | Brake cable |
| Fit Years | 1976-1978 |
| Machine | for John Deere Cyclone 440 |
Good To Know
Q: Does the cable come pre-lubricated? A: Light lubrication of the inner cable before installation helps it move smoothly and extends its service life. Inspect the lever and brake assembly at the same time for worn pivots.
Q: How do I set the correct cable tension? A: Adjust the cable adjuster so the brake engages with a small amount of lever free play, following the factory setting for the Cyclone 440. Confirm the brake releases fully when the lever is let go.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
