Brake Cable for John Deere Liquifire 440 1976-1978

Brake Cable for John Deere Liquifire 440

This brake cable is a direct replacement for the John Deere Liquifire 440 snowmobile, running from the brake lever to the caliper to restore reliable stopping power.

Overview

This brake cable is built to replace a worn or seized unit on the John Deere Liquifire 440. It delivers smooth lever travel and consistent braking response so you can ride with confidence. A smart choice for riders maintaining a classic snowmobile for trail or vintage use.

Built For Performance

• Constructed from braided steel inner cable for strength and low stretch
• Protective outer sheath resists moisture and abrasion
• Pre-lubricated for smooth operation right out of the package
• Correct length for a proper fit on the Liquifire 440
• Corrosion-resistant end fittings for lasting service

Fits These Machines

• for John Deere Liquifire 440 1976
• for John Deere Liquifire 440 1977
• for John Deere Liquifire 440 1978

On-The-Job Use

• Trail riding where dependable braking matters
• Vintage snowmobile restoration projects
• Routine maintenance on older machines
• Replacing a frayed or frozen cable

Specs At A Glance

Good To Know

Q: How do I know if my brake cable needs replacing? A: A frayed cable, stiff lever, or inconsistent braking usually points to a worn cable that should be swapped out before riding.

Q: Is installation difficult? A: Most riders can route and install a brake cable with basic hand tools, though checking lever adjustment afterward is recommended.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.