Brake Cable for Moto-Ski Mirage III 1985
Brake Cable for Moto-Ski Mirage III 1985
Couldn't load pickup availability
Brake Cable for Moto-Ski Mirage III
A replacement brake cable built to suit the 1985 Moto-Ski Mirage III, this cable transfers lever pull to the brake assembly so you keep dependable stopping control on the snow.
Overview
This brake cable is a direct-fit replacement intended for the 1985 Moto-Ski Mirage III snowmobile. It carries the pull from the handlebar brake lever to the brake mechanism so you can slow and stop reliably. A practical pick for riders maintaining or reviving a Mirage III.
Built For Performance
- Inner cable slides smoothly through the outer housing for easy lever pull
- Protective housing guards the inner wire against moisture and debris
- Pre-formed end fittings match the lever and brake connections
- Built to hold tension through repeated brake application
- Cut to a length suited to the Mirage III layout
Fits These Machines
- for Moto-Ski Mirage III, 1985
On-The-Job Use
- Replacing a worn or stretched cable during sled servicing
- Restoring safe brake response on a vintage snowmobile
- Routine maintenance ahead of the riding season
- Bringing a stored machine back into trail-ready condition
Specs At A Glance
| Application | Brake cable |
| Machine | for Moto-Ski Mirage III |
| Model Year | 1985 |
Good To Know
Q: Will this fit my exact Mirage III? A: It is listed for the 1985 Mirage III, but fit can vary by serial number. Confirm your machine details before ordering.
Q: Do I need to adjust the new cable after install? A: Yes, brake cables typically need tension adjustment at the lever or brake end after fitting. Set the free play per your service manual.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
