Brake Switch Stop Sensor For Can Am Commander 800 1000 For 705601250

Brake Switch Stop Sensor for Can Am Commander 800 1000

This brake switch stop sensor replaces OEM part 705601250 to activate brake lights and signal braking on Can Am Commander 800 and 1000 side-by-side vehicles.

Overview

This brake switch stop sensor is built to restore reliable brake light activation on Can Am Commander 800 and 1000 machines. The brake sensor compresses when the pedal is pressed to close the circuit and trigger the lights. It serves riders replacing a worn or failed OEM sensor with a direct-fit replacement brake switch.

Built For Performance

• Direct replacement for OEM part number 705601250
• Weather-sealed connector to resist mud, dust, and water spray
• Positive contact engagement for consistent brake light response
• Matches factory mounting points for bolt-on installation
• Housing built to handle trail vibration and temperature swings

Fits These Machines

• for Can Am Commander 800
• for Can Am Commander 1000

On-The-Job Use

• Trail riding where brake light visibility matters
• Farm and ranch use around animals and equipment
• Fleet maintenance on side-by-side utility vehicles
• Repairing brake lights that stay on or fail to light

Specs At A Glance

Good To Know

Q: How do I know my brake switch has failed? A: Common signs include brake lights that stay lit constantly or never illuminate when the pedal is pressed. A failed switch can also interfere with engine braking logic on some machines.

Q: Is installation straightforward? A: The sensor mounts at the factory location and connects to the existing harness. Basic hand tools are usually enough, but consult your service manual for the correct procedure.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.