Bronco Intake Valve for Honda Fourtrax 300 2x4 & 4x4 1988-2000 TRX300 TRX300FW

Intake Valve for for Honda

This intake valve for for Honda Fourtrax 300 is a critical engine component responsible for regulating the fuel and air mixture entering the combustion chamber.

Overview

The intake valve for for Honda is precision-engineered to withstand the high-heat cycles of the engine while maintaining a perfect seal. A properly functioning intake valve for for Honda ensures maximum power and efficiency for your ATV. This intake valve for for Honda is a replacement part for models including the TRX300 and TRX300FW.

Built For Performance

• Heat-treated steel alloy construction
• Precision-ground valve face
• High resistance to thermal fatigue
• Direct fitment for original valvetrain

Fits These Machines

• for Honda Fourtrax 300 2x4 (1988-2000)
• for Honda Fourtrax 300 4x4 (1988-2000)

On-The-Job Use

• Engine top-end rebuilds
• Valve lash adjustment servicing
• Restoring compression lost to valve wear

Good To Know

Q: Should I replace the valve seals at the same time? A: It is standard procedure to replace valve seals whenever you perform a valve service to prevent oil consumption.

Q: Does the valve seat need to be lapped? A: Lapping the valve to the seat during installation is highly recommended to ensure an airtight seal.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.