BW80 Rear Wheel Bearings and Seals for Yamaha BW80 Big Wheel 1986-1990 BW 80

Rear Wheel Bearings and Seals for Yamaha BW80 Big Wheel

This rear wheel bearing and seal kit is made to replace the worn rear wheel bearings and seals on the Yamaha BW80 Big Wheel, keeping the rear wheel turning smoothly and protecting the hub from dirt and moisture.

Overview

This rear wheel bearings and seals kit is built for the Yamaha BW80 Big Wheel and restores smooth rear wheel rotation by replacing worn bearings and tired seals. Each rear wheel bearings and seals set keeps dust, water, and grit out of the hub so the wheel spins freely on the trail. It is a straightforward maintenance fix for riders keeping a BW80 Big Wheel in service.

Built For Performance

• Complete rear wheel bearing and seal set for both sides of the rear wheel
• Seals block dirt, water, and grit from reaching the bearing races
• Bearings are sized to match the BW80 Big Wheel rear hub bore and axle
• Steel construction resists wear under repeated off-road loads
• Direct replacement for the original rear wheel bearings and seals

Fits These Machines

• for Yamaha BW80 Big Wheel 1986
• for Yamaha BW80 Big Wheel 1987
• for Yamaha BW80 Big Wheel 1988
• for Yamaha BW80 Big Wheel 1989
• for Yamaha BW80 Big Wheel 1990

On-The-Job Use

• Restoring a rough or noisy rear wheel on a BW80 Big Wheel
• Routine wheel service after riding in mud, sand, or water
• Trail and field riding where rear wheel bearings take a beating
• Refreshing a project or vintage Yamaha Big Wheel before riding season

Specs At A Glance

Good To Know

Q: Do I need to replace the seals when I replace the rear wheel bearings? A: Yes, new seals are included and should be fitted at the same time so grit cannot get back into the fresh bearings and shorten their life.

Q: Are these genuine Yamaha parts? A: No, this is an aftermarket rear wheel bearings and seals kit made for Yamaha BW80 Big Wheel models and is not an original Yamaha product.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.