Camshaft Position Sensor For Mercedes-Benz 300SE W140 1992-1993 L6 3.2L

Camshaft Position Sensor for Mercedes-Benz

This camshaft position sensor for Mercedes-Benz monitors camshaft rotation and relays timing signals to the engine control unit so fuel delivery and ignition stay synchronized.

Overview

This camshaft position sensor for Mercedes-Benz is a direct-fit replacement for the original sensor on 1992-1993 300SE W140 models with the 3.2L L6 engine. It reads camshaft position and sends that signal to the ECU, helping the engine run smoothly and start reliably. Ideal for owners replacing a failed or intermittent sensor.

Built For Performance

• Reads camshaft rotation to support accurate ignition timing
• Seals against oil and heat in the engine bay
• Plug-in connector matches the factory harness
• Solid-state pickup designed for consistent signal output
• Direct-fit dimensions for the 3.2L L6 engine

Fits These Machines

• for Mercedes-Benz 300SE W140 1992-1993 L6 3.2L

On-The-Job Use

• Restoring smooth idle after a failed sensor
• Fixing hard starting or stalling tied to timing signal loss
• Routine replacement during engine service

Specs At A Glance

Good To Know

Q: Will this fit any W140 model? A: It is listed for the 1992-1993 300SE with the 3.2L L6 engine. Check your engine code and serial number before ordering.

Q: Do I need to clear codes after installation? A: Yes, clear stored fault codes after replacing the sensor so the ECU can relearn the signal. A scan tool makes this quick.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.