Carb Flange Boot Intake Joint for Yamaha Warrior 350 & 1995 Wolverine

Carb Flange Boot Intake Joint for Yamaha Warrior 350 and 1995 Wolverine

This carb flange boot intake joint provides a seal between the carburetor and engine on Yamaha Warrior 350 and 1995 Wolverine ATVs, preventing air leaks and ensuring proper fuel mixture.

Overview

The carb flange boot intake joint is designed for Yamaha Warrior 350 and 1995 Yamaha Wolverine models. This rubber boot connects the carburetor to the intake manifold or cylinder head, creating an airtight seal. A cracked or worn intake joint can cause lean running conditions, so replacing it restores engine performance and idle stability.

Built For Performance

• Made from durable rubber resistant to heat and fuel vapors
• Precisely molded to match OEM flange dimensions
• Ensures proper sealing to prevent vacuum leaks
• Easy to install with basic hand tools
• Restores throttle response and idle quality

Fits These Machines

• for Yamaha Warrior 350
• for Yamaha Wolverine 1995

On-The-Job Use

• Replacing deteriorated intake boots during carburetor rebuilds
• Fixing rough idle or stalling caused by air leaks
• Maintaining proper air-fuel ratio for reliable operation
• Typical replacement part for aging ATV engines

Specs At A Glance

Good To Know

Q: What symptoms indicate a bad intake boot? A: Rough idle, backfiring, hesitation, and difficulty starting are common signs of a leaking intake joint.

Q: Is this boot the same for the Warrior and Wolverine? A: The boot is designed to fit both models, but always confirm compatibility with your specific engine.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.