Carb Flange Boot Intake Joint w/ O-Ring for Yamaha Warrior 350 & 1995 Wolverine

Carb Flange Boot Intake Joint with O-Ring for Yamaha Warrior 350 and 1995 Wolverine

This carb flange boot intake joint with o-ring connects the carburetor to the engine on Yamaha Warrior 350 and 1995 Yamaha Wolverine ATVs, ensuring an airtight seal for proper fuel-air mixture.

Overview

This carb flange boot intake joint with o-ring is designed for Yamaha Warrior 350 and 1995 Yamaha Wolverine ATVs, replacing worn or cracked intake boots to restore engine performance. The carb flange boot includes an o-ring for a leak-free seal and exactly replicates the original part. Whether for the Warrior 350 or the 1995 Wolverine, this intake joint ensures reliable carburetor connection.

Built For Performance

• Reinforced rubber construction resists cracking
• Includes o-ring for leak-free seal
• Direct replacement for original intake boot
• Heat-resistant material withstands engine temperature
• Precision-molded to fit stock carburetor

Fits These Machines

• for Yamaha Warrior 350
• for Yamaha Wolverine (1995)

On-The-Job Use

• Carburetor intake system repair
• Restoring idle and acceleration
• Replacing cracked or brittle boots
• Engine rebuild or maintenance

Specs At A Glance

Good To Know

Q: How do I install this intake boot? A: Installation involves removing the old boot, cleaning the mating surfaces, then pressing the new carb flange boot into place with the o-ring seated correctly.

Q: Will this fit other Yamaha models? A: This carb flange boot is specifically designed for Yamaha Warrior 350 and 1995 Wolverine; other models may require different part numbers.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.