Carb Flange Boot Joint for Yamaha Bear Tracker 250 Replaces OEM# 4XE-13586-00-00

Carb Flange Boot Joint for Yamaha Bear Tracker 250

This carb flange boot joint replaces OEM part number 4XE-13586-00-00 for Yamaha Bear Tracker 250 ATVs, sealing the carburetor intake to prevent air leaks and maintain proper air-fuel mixture.

Overview

This carb flange boot joint is a direct replacement for the OEM 4XE-13586-00-00 rubber intake boot on Yamaha Bear Tracker 250 models. It seals the carburetor to the engine, preventing vacuum leaks that cause rough idling and poor throttle response. Designed for easy installation, this boot joint restores reliable engine performance for ATV owners.

Built For Performance

• Made from flexible, oil-resistant rubber to withstand engine heat and vibration
• Exact OEM dimensions ensure a snug, leak-free fit
• Reinforced ends resist cracking over time
• Simple plug-and-play replacement with basic hand tools
• Compatible with ethanol-blended fuels commonly used in ATVs
• Includes necessary sealing surfaces for a secure intake tract connection

Fits These Machines

• for Yamaha Bear Tracker 250

On-The-Job Use

• Replacing a cracked or hardened carb intake boot
• Restoring idle stability after an air leak diagnosis
• Servicing the carburetor during an overhaul or cleaning
• Maintaining low-end torque for utility tasks

Specs At A Glance

Good To Know

Q: Can I reuse the original clamps with this boot? A: Yes, the original clamps typically work, but replacing them with new stainless steel clamps is recommended to ensure a tight seal.

Q: Should I apply sealant to the boot edges? A: No sealant is needed; the rubber-to-metal contact creates an air-tight seal when properly tightened.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.