Carbon Ring Kit for Sea-Doo 3D DI 951 2006-2007

Carbon Ring Kit for Sea-Doo 3D DI 951

This carbon ring kit is a replacement seal assembly for the driveshaft on the Sea-Doo 3D DI 951, built to seal the shaft tunnel and keep water out of the hull.

Overview

This carbon ring kit services the shaft seal on the Sea-Doo 3D DI 951, covering the 2006 to 2007 model years. The carbon ring kit provides the sealing ring and related components needed to renew a worn or leaking driveshaft seal. It is intended for owners and technicians handling driveline maintenance on this watercraft.

Built For Performance

• Carbon sealing ring sized for the Sea-Doo 3D DI 951 shaft tunnel
• Forms a watertight barrier at the driveshaft pass-through
• Kit includes the ring and supporting hardware for one service
• Replacement-grade construction for repeated marine use
• Fitment designed for the 2006 to 2007 Sea-Doo 3D DI 951

Fits These Machines

• for Sea-Doo 3D DI 951 (2006)
• for Sea-Doo 3D DI 951 (2007)

On-The-Job Use

• Driveshaft seal service on jet drives
• Correcting water intrusion at the shaft tunnel
• Seasonal driveline inspection and refresh
• Garage or shop rebuilds of the shaft seal assembly

Specs At A Glance

Good To Know

Q: What is the carbon ring kit responsible for on a jet drive? A: It seals the point where the driveshaft passes through the hull, blocking water from entering the engine bay. A failing ring allows seepage that can affect performance and corrosion resistance.

Q: When should the carbon ring be replaced? A: Replace it when you notice water in the hull, visible wear on the ring, or a poor seal against the mating surface. Checking it during regular driveline service helps catch problems early.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.