Carbon Ring Kit for Sea-Doo Challenger 720 1998 2000-2001

Carbon Ring Kit for Sea-Doo Challenger 720

The carbon ring kit is a driveshaft seal assembly that fits 1998, 2000-2001 Sea-Doo Challenger 720 models, sealing the driveshaft opening in the hull so water stays out of the engine bay.

Overview

This carbon ring kit is made for the 1998, 2000-2001 Sea-Doo Challenger 720 and provides the sealing components needed to rebuild the driveshaft seal point. The carbon ring kit keeps water from passing through the hull around the spinning driveshaft. It suits Challenger 720 owners handling routine driveline and pump maintenance.

Built For Performance

• Carbon sealing ring sized for the driveshaft
• Rubber boot presses the ring against the rotating surface
• Stainless clamps hold the boot firmly in place
• Direct replacement for the original seal arrangement
• Wear resistant materials for continuous service
• Complete kit for rebuilding the seal assembly

Fits These Machines

• for Sea-Doo Challenger 720, 1998
• for Sea-Doo Challenger 720, 2000
• for Sea-Doo Challenger 720, 2001

On-The-Job Use

• Driveshaft seal replacement during pump service
• Hull leak diagnosis around the driveshaft opening
• Routine driveline maintenance on the Challenger 720
• Rebuilding the seal assembly after water intrusion

Specs At A Glance

Good To Know

Q: When should the carbon ring kit be replaced? A: Most owners replace the carbon ring kit during routine pump or driveshaft service, or sooner if water is found entering at the driveshaft seal.

Q: Does the kit require special tools? A: The carbon ring kit installs at the driveshaft pass-through point and is commonly done during pump removal, so basic mechanical experience helps.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.