Carbon Ring Kit for Sea-Doo GS 720 1997-2001

Carbon Ring Kit for Sea-Doo GS 720

This carbon ring kit is a driveshaft seal solution for the Sea-Doo GS 720, replacing the worn carbon ring and related sealing components on 1997-2001 models.

Overview

The carbon ring kit for Sea-Doo GS 720 restores the driveshaft seal on 1997-2001 personal watercraft so water stays out of the hull. This carbon ring kit gives riders a direct replacement for the worn sealing ring that wears down with hours on the water. It is built for riders and mechanics servicing Sea-Doo GS 720 machines.

Built For Performance

• Carbon sealing ring designed to ride against the driveshaft collar for a consistent seal
• Direct replacement for the factory carbon ring on 1997-2001 Sea-Doo GS 720 models
• Kit format so the ring and related sealing hardware arrive together
• Resists water intrusion at the through-hull driveshaft opening
• Suited to routine wear replacement and driveline service

Fits These Machines

• for Sea-Doo GS 720
• for Sea-Doo GS 720 (1997-2001)

On-The-Job Use

• Replacing a worn or leaking carbon ring during driveshaft service
• Routine maintenance on 1997-2001 Sea-Doo GS 720 watercraft
• Resealing the hull opening where the driveshaft passes through
• Shop or DIY repair where the original sealing ring has failed

Specs At A Glance

Good To Know

Q: What does a carbon ring kit do on a Sea-Doo GS 720? A: It provides the sealing ring that stops water from entering the hull where the driveshaft passes through, replacing the original ring as it wears. A: The kit is intended for 1997-2001 GS 720 models, so confirm your hull and engine match before ordering.

Q: How often should the carbon ring be replaced? A: Replacement depends on hours of use and wear, so inspect the ring during driveline service and replace it when it shows scoring or leakage.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.