Carbon Ring Kit for Sea-Doo GSX LTD 951 1999 PWC Jet Ski Part

Carbon Ring Kit for Sea-Doo

This carbon ring kit is a driveshaft seal assembly for Sea-Doo personal watercraft, built to replace a worn carbon ring and keep water from entering the hull at the driveshaft pass-through.

Overview

This carbon ring kit for Sea-Doo provides the sealing components needed to service the driveshaft seal on GSX LTD 951 models. The carbon ring kit for Sea-Doo is aimed at riders and technicians doing routine pump and driveshaft work. A fresh carbon ring kit for Sea-Doo helps keep the seal seated against the driveshaft so water stays out of the hull.

Built For Performance

• Carbon ring material chosen for low friction against the driveshaft sealing face
• Kit format so the seal parts are replaced as a set
• Engineered to hold the watertight seal at the hull pass-through
• Suited to routine PWC driveshaft and pump service
• Direct replacement fit for the listed 951 powered model

Fits These Machines

• for Sea-Doo GSX LTD 951 (1999)

On-The-Job Use

• Driveshaft seal service during pump maintenance
• Refreshing the carbon ring seal after wear or water intrusion
• Seasonal PWC tune-ups on 951 powered GSX LTD models
• Repair work after pulling the pump or driveshaft

Good To Know

Q: Why replace this carbon ring kit? A: A worn carbon ring lets water enter the hull through the driveshaft seal. Replacing the kit restores the seal at the hull pass-through.

Q: Is this an original Sea-Doo part? A: This is an aftermarket carbon ring kit for Sea-Doo personal watercraft. It is not an original manufacturer part.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.