Carbon Ring Kit for Sea-Doo GTI 130 1503 2016

Carbon Ring Kit for Sea-Doo

This carbon ring kit is a driveline sealing component designed to fit the 1503 engine platform, serving as the replacement seal that keeps water out of the driveshaft tunnel on your personal watercraft.

Overview

The carbon ring kit provides the sealing element used where the driveshaft passes through the hull on a 1503-equipped personal watercraft. It renews the sealing surface that prevents water from entering the engine bay while the pump and shaft spin at speed. This kit suits riders performing routine driveline maintenance on their GTI 130.

Built For Performance

• Sealing ring sized for the 1503 driveshaft application
• Carbon face material engineered for continuous rotation contact
• Designed to hold the seal as the shaft spins under load
• Replacement part for worn or leaking original sealing components
• Direct-fit for the GTI 130 driveline layout

Fits These Machines

• for Sea-Doo GTI 130 1503, 2016

On-The-Job Use

• Routine driveline service on personal watercraft
• Resealing the shaft tunnel after a leak is found
• Seasonal maintenance before launching the craft
• Repair work following driveline disassembly

Specs At A Glance

Good To Know

Q: What does a carbon ring kit do on a personal watercraft? A: It provides the rotating seal at the driveshaft where it exits the hull, keeping water out of the engine compartment. A worn ring shows up as water intrusion or driveline noise.

Q: When should the carbon ring be replaced? A: Replacement is typically due when water is found in the hull, the seal face is scored, or the driveline is being serviced. Confirm the engine platform matches before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.