Carbon Ring Kit for Sea-Doo GTI 720 1996-2005 PWC Jet Ski Part

Carbon Ring Kit for Sea-Doo

This carbon ring kit is a driveshaft seal assembly for Sea-Doo personal watercraft, designed to replace a worn carbon ring and keep water out of the hull where the driveshaft passes through.

Overview

This carbon ring kit for Sea-Doo delivers the sealing components needed to refresh the driveshaft seal on GTI 720 models. The carbon ring kit for Sea-Doo is intended for riders and mechanics handling routine pump and driveshaft maintenance. A healthy carbon ring kit for Sea-Doo helps hold the seal tight against the driveshaft carrier so water stays where it belongs.

Built For Performance

• Carbon ring formulated for low friction against the driveshaft sealing surface
• Kit form so the seal components can be replaced together
• Designed to maintain the watertight seal at the hull pass-through
• Suited to routine PWC driveshaft and pump maintenance
• Direct replacement fit for the listed 720 powered models

Fits These Machines

• for Sea-Doo GTI 720 (1996-2005)

On-The-Job Use

• Driveshaft seal service during pump maintenance
• Refreshing the carbon ring seal after wear or water intrusion
• Seasonal PWC tune-ups on 720 powered GTI models
• Repair work after pulling the pump or driveshaft

Good To Know

Q: Why replace this carbon ring kit? A: A worn carbon ring lets water enter the hull through the driveshaft seal. Replacing the kit restores the seal at the hull pass-through.

Q: Is this an original Sea-Doo part? A: This is an aftermarket carbon ring kit for Sea-Doo personal watercraft. It is not an original manufacturer part.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.