Carbon Ring Kit for Sea-Doo GTI STD 130 1630 2020-2026

Carbon Ring Kit for Sea-Doo

This carbon ring kit is a driveshaft seal component that helps keep water out of the hull on personal watercraft, and it is built for Sea-Doo GTI STD 130 1630 models from 2020 through 2026.

Overview

This carbon ring kit for Sea-Doo delivers a fresh sealing surface at the driveshaft pass-through, helping limit water intrusion while you ride. It is a direct-fit replacement for the carbon ring and related sealing hardware on 1630-powered GTI STD 130 craft. Riders and mechanics performing routine driveline maintenance will find this carbon ring kit a practical service item.

Built For Performance

• Carbon sealing ring engineered for the driveshaft sealing surface
• Designed to fit 1630 engine GTI STD 130 applications from 2020 to 2026
• Helps reduce water entry at the through-hull driveshaft opening
• Kit format supports a complete service of the ring and mating components
• Marine-grade materials suited to repeated wet use

Fits These Machines

• for Sea-Doo GTI STD 130 1630, model years 2020 to 2026

On-The-Job Use

• Routine driveshaft seal service on 1630-powered GTI STD 130 craft
• Replacing a worn carbon ring after water intrusion is noticed
• Pre-season maintenance before launching for the summer
• Shop repairs where the driveshaft seal assembly is being refreshed

Specs At A Glance

Good To Know

Q: Does this carbon ring kit fit both the STD 130 and SE 170 versions of the GTI? A: This listing is specified for the GTI STD 130 1630 from 2020 to 2026, so confirm your exact model and year before ordering. Q: Is any special tooling needed for installation? A: Driveshaft seal work on personal watercraft generally calls for basic hand tools and careful alignment, so follow the service manual procedure for your craft.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.