Carbon Ring Kit for Sea-Doo GTS 580 1996 PWC Jet Ski Part

Carbon Ring Kit for Sea-Doo GTS 580

This carbon ring kit is a direct-fit replacement driveline seal set for the Sea-Doo GTS 580, designed to keep the driveshaft sealing surface tight and water out of the hull.

Overview

This carbon ring kit for Sea-Doo restores the sealing surface at the driveshaft where water can otherwise creep past a worn ring. The carbon ring kit for Sea-Doo GTS 580 is built for riders doing their own pump and driveline maintenance on older personal watercraft. It is a practical service part for anyone keeping a 1996 GTS 580 on the water.

Built For Performance

• Carbon sealing ring sized for the GTS 580 driveshaft
• Direct replacement for the original ring and related sealing components
• Resists wear from continuous shaft rotation and water exposure
• Helps maintain a proper seal between the driveshaft and hull opening
• Kit form so related sealing pieces arrive together

Fits These Machines

• for Sea-Doo GTS 580, 1996

On-The-Job Use

• Routine driveline service on a 1996 GTS 580
• Replacing a worn or leaking carbon ring during pump maintenance
• Seasonal tear-down and inspection of the driveshaft sealing area

Specs At A Glance

Good To Know

Q: What does the carbon ring actually do? A: It forms the sealing surface where the driveshaft passes through the hull, keeping water out while the shaft spins. A worn ring can let water into the engine compartment.

Q: Do I need any special tools to install it? A: Basic hand tools and access to the driveshaft area are usually enough, though the pump may need to come off first. Follow your service manual for the correct sequence.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.