Carbon Ring Kit for Sea-Doo GTX 800 1996-1997 PWC Jet Ski Part

Carbon Ring Kit for Sea-Doo GTX 800

This carbon ring kit is a drive line sealing assembly for the Sea-Doo GTX 800 that replaces the worn carbon seal ring and keeps water out of the hull where the driveshaft passes through.

Overview

The carbon ring kit for Sea-Doo GTX 800 restores the seal at the driveshaft tunnel on 1996 through 1997 models. This carbon ring kit is intended for riders and mechanics servicing the jet pump drive line, and it installs in place of the original sealing ring. The carbon ring kit includes the sealing components needed to rebuild the drive line seal point.

Built For Performance

• Carbon sealing ring sized for the Sea-Doo GTX 800 drive line
• Direct replacement for the original sealing ring location
• Designed for the 1996 through 1997 model run
• Withstands the water and vibration of jet pump operation
• Kit form so the seal point can be refreshed in one job
• Fits the drive line assembly without machining

Fits These Machines

• for Sea-Doo GTX 800 1996
• for Sea-Doo GTX 800 1997

On-The-Job Use

• Replacing a worn or leaking drive line seal on the GTX 800
• Routine drive line service on 1996 and 1997 models
• Rebuilding the seal point before the season starts
• Shop repairs where water intrusion at the driveshaft seal is found

Specs At A Glance

Good To Know

Q: Is this an original Sea-Doo part? A: No, this is an aftermarket replacement carbon ring kit for Sea-Doo applications. It is designed to fit the listed model and years.

Q: Do I need to remove the jet pump to install it? A: The carbon seal sits on the drive line inside the hull, so access is through the engine compartment rather than the pump. Follow your service manual for the proper removal and seating procedure.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.