Carbon Ring Kit for Sea-Doo GTX DI 951 2000-2003 PWC

Carbon Ring Kit for Sea-Doo GTX DI 951

This carbon ring kit is a driveline sealing component that helps keep water out of the hull where the driveshaft passes through on 2000-2003 Sea-Doo GTX DI 951 models.

Overview

This carbon ring kit provides the sealing surface that rides against the driveshaft seal carrier in the through-hull assembly on 2000-2003 Sea-Doo GTX DI 951 personal watercraft. The carbon ring kit is designed for riders and mechanics replacing a worn or cracked ring that allows water intrusion or causes driveline noise. Each carbon ring kit is a direct-fit service item for routine driveline maintenance on these models.

Built For Performance

• Carbon sealing ring sized for the 951 DI driveline through-hull assembly
• Kit includes the sealing components needed for the driveshaft pass-through area
• Machined sealing face designed to run against the seal carrier under load
• Heat and friction resistant material suited to continuous PWC operation
• Direct replacement for the factory carbon ring on 2000-2003 GTX DI 951 models

Fits These Machines

• for Sea-Doo GTX DI 951 (2000-2003)

On-The-Job Use

• Routine driveline service when the carbon ring shows cracks or wear
• Repairs after water intrusion is found around the driveshaft pass-through
• Driveline refresh during engine or jet pump service on GTX DI 951 models
• Seasonal maintenance before launching the craft

Specs At A Glance

Good To Know

Q: How do I know if the carbon ring needs replacing? A: Common signs include water accumulating near the driveshaft pass-through, a cracked or scored carbon face, or unusual driveline noise. Inspecting the ring during driveline service is the surest way to catch wear early.

Q: Does this kit include everything needed for the job? A: The kit supplies the carbon ring sealing components for the through-hull driveline area on the listed models. Confirm your craft's serial number and existing seal carrier condition before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.