Carbon Ring Kit for Sea-Doo GTX Fish Pro 170 1630 2020-2021

Carbon Ring Kit for Sea-Doo

This carbon ring kit is a replacement sealing component for the driveshaft on personal watercraft, helping keep water out of the hull where the shaft passes through the seal carrier.

Overview

This carbon ring kit for Sea-Doo delivers a fresh sealing surface for your jet pump driveshaft assembly. The carbon ring kit for Sea-Doo is built to reduce water intrusion and keep the floating seal running true against the stainless hat. Riders performing routine driveline maintenance will find the carbon ring kit for Sea-Doo a practical replacement for a worn or grooved ring.

Built For Performance

• Carbon ring material designed for low friction against the sealing surface
• Helps maintain a proper seal where the driveshaft exits the hull
• Replacement part for worn sealing rings on 1630cc engine models
• Suited to periodic driveline service and wear-part replacement

Fits These Machines

• for Sea-Doo GTX Fish Pro 170 1630
• for Sea-Doo GTX Fish Pro 170 1630 2020
• for Sea-Doo GTX Fish Pro 170 1630 2021

On-The-Job Use

• Routine driveshaft seal service on GTX Fish Pro models
• Replacing a carbon ring that shows grooves or excessive wear
• Driveline refresh during jet pump or impeller service
• Seasonal maintenance before launching

Specs At A Glance

Good To Know

Q: What does the carbon ring do on a PWC driveshaft? A: It provides the rotating sealing face that keeps water from entering the hull along the driveshaft. Over time the ring wears and should be replaced to maintain a proper seal.

Q: Should I inspect other driveline parts at the same time? A: Yes, it is common to check the sealing hat, boot, and support ring while the driveshaft is apart. Replacing worn items together can help avoid repeat labor.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.