Carbon Ring Kit for Sea-Doo GTX LTD 951 1998-1999 PWC

Carbon Ring Kit for Sea-Doo

This carbon ring kit fits the driveshaft seal on 1998-1999 Sea-Doo GTX LTD 951 personal watercraft and helps keep water out of the hull where the driveshaft meets the engine. The carbon ring kit gives riders a direct replacement for a worn sealing ring on Sea-Doo GTX LTD 951 models.

Overview

The carbon ring kit is a driveshaft sealing component for 1998-1999 Sea-Doo GTX LTD 951 watercraft. It seals the passage where the driveshaft enters the hull, keeping cooling water and spray out of the engine bay. This carbon ring kit suits riders performing routine driveline maintenance on Sea-Doo GTX LTD 951 machines.

Built For Performance

• Carbon sealing ring sized for the Sea-Doo GTX LTD 951 driveshaft through-hull fitting
• Includes ring and boot hardware for a complete seal replacement
• Carbon material resists wear from continuous driveshaft rotation
• Direct fit for the 1998-1999 Sea-Doo GTX LTD 951 hull assembly
• Seals the through-hull opening against water intrusion during riding

Fits These Machines

• for Sea-Doo GTX LTD 951, 1998
• for Sea-Doo GTX LTD 951, 1999

On-The-Job Use

• Routine driveshaft seal replacement on 1998-1999 Sea-Doo GTX LTD 951
• Repair after water intrusion is found in the hull near the driveshaft
• Scheduled driveline maintenance before the riding season starts
• Replacing a worn or leaking carbon ring at the through-hull fitting

Specs At A Glance

Good To Know

Q: Does this kit fit models outside the listed years? A: This kit is listed for 1998-1999 Sea-Doo GTX LTD 951 only, so confirm your model and year before ordering. A: Fitment can vary by serial number, so check your hull identification number against the listing.

Q: Is installation difficult? A: Replacing the carbon ring requires removing the driveshaft on most Sea-Doo models, so mechanical experience is recommended. A: A service manual for your model year will guide the correct torque and reassembly steps.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.