Carbon Ring Kit for Sea-Doo GTX LTD S/C 1503 2003-2004

Carbon Ring Kit for Sea-Doo GTX LTD S/C 1503

This carbon ring kit is a driveshaft seal component made for the Sea-Doo GTX LTD S/C 1503, designed to keep water out of the hull where the driveshaft passes through.

Overview

This carbon ring kit is a replacement seal assembly made for the Sea-Doo GTX LTD S/C 1503. It seals the driveshaft passage to help keep bilge water from entering through the hull fitting. Riders performing routine driveline maintenance on this model choose a carbon ring kit to restore proper sealing.

Built For Performance

• Carbon sealing ring sized for the 1503 driveline
• Designed to maintain a watertight seal at the driveshaft pass-through
• Direct-fit replacement for the factory sealing arrangement
• Constructed for marine use in fresh and salt water
• Includes the sealing components needed for installation

Fits These Machines

• for Sea-Doo GTX LTD S/C 1503, 2003
• for Sea-Doo GTX LTD S/C 1503, 2004

On-The-Job Use

• Routine driveline and hull seal maintenance
• Replacing a worn or leaking carbon ring
• PWC service and repair work
• Seasonal pre-ride inspections

Specs At A Glance

Good To Know

Q: What does a carbon ring kit do on a Sea-Doo GTX LTD S/C 1503? A: It seals the point where the driveshaft exits the hull, helping prevent water from entering the engine compartment. A worn ring can allow water intrusion and should be replaced as part of driveline service.

Q: Should the carbon ring be replaced during driveline work? A: Yes, it is commonly replaced whenever the driveshaft assembly is serviced on this model. Confirm your serial number and model year before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.