Carbon Ring Kit for Sea-Doo LRV DI 951 2002-2003 PWC

Carbon Ring Kit for Sea-Doo LRV DI 951

This Carbon Ring Kit is a driveline sealing component that replaces the worn carbon seal ring in the rotating shaft assembly on 2002-2003 Sea-Doo LRV DI 951 personal watercraft.

Overview

This Carbon Ring Kit restores the sealing surface between the driveshaft and the hull passage on the Sea-Doo LRV DI 951. The carbon ring kit is built to control water ingress at the through-hull fitting, keeping the engine bay dry under load. It is intended for riders performing routine driveline maintenance on their 2002-2003 Sea-Doo LRV DI 951.

Built For Performance

• Carbon ring material designed for wet-running seal service
• Direct-fit replacement for the stock carbon seal ring
• Withstands continuous rotational contact at the driveshaft
• Resists wear from grit and debris in the water flow
• Compatible with the 951 DI engine driveline configuration

Fits These Machines

• for Sea-Doo LRV DI 951 (2002)
• for Sea-Doo LRV DI 951 (2003)

On-The-Job Use

• Routine driveshaft seal replacement on the LRV DI 951
• Driveline refresh during engine or pump service
• Repairing water intrusion at the through-hull seal
• Pre-season maintenance before riding season

Specs At A Glance

Good To Know

Q: What does a carbon ring kit do on a Sea-Doo? A: It seals the driveshaft where it passes through the hull, preventing water from entering the engine compartment. The carbon ring wears over time and should be replaced when sealing performance drops.

Q: Does this kit fit other Sea-Doo models? A: This kit is listed for the 2002-2003 LRV DI 951. Confirm your model and year before ordering, since fit can vary across the Sea-Doo lineup.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.