Carbon Ring Kit for Sea-Doo Sportster LT 720 2002 Boat

Carbon Ring Kit for Sea-Doo Sportster LT 720

This carbon ring kit is a driveshaft seal set that replaces the worn carbon ring and related sealing components on a 2002 Sea-Doo Sportster LT 720, keeping water out of the hull where the driveshaft passes through.

Overview

This carbon ring kit for Sea-Doo Sportster LT 720 is a direct-fit sealing set for the driveshaft pass-through on 2002 models. The kit refreshes the carbon ring, boot, and retaining hardware so the seal runs true against the driveshaft. It is built for owners servicing their own jet boat rather than paying a dealer for a simple seal swap.

Built For Performance

• Carbon ring formulated for continuous contact against a rotating driveshaft
• Reinforced rubber boot resists cracking from heat and bilge water
• Stainless retaining ring and clamp resist corrosion in wet environments
• Pre-sized components seat without hand trimming
• Direct replacement for worn factory sealing hardware

Fits These Machines

• for Sea-Doo Sportster LT 720
• for Sea-Doo Sportster 720 models using the same driveshaft seal setup

On-The-Job Use

• Routine driveshaft seal replacement during seasonal service
• Fixing water intrusion at the hull pass-through
• Repairing a worn or cracked carbon ring before it damages the driveshaft
• Trailer-side maintenance for DIY boat owners

Specs At A Glance

Good To Know

Q: How often should a carbon ring be replaced? A: Most owners replace it every few seasons or whenever water is found weeping past the seal. Inspect it any time the driveshaft is pulled for service.

Q: Does this kit need special tools? A: Basic hand tools handle the job, though a strap wrench helps hold the driveshaft. Confirm the shaft is clean and free of grooves before installing.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.