Carbon Ring Kit for Sea-Doo SPX 720 1996 Jet Ski Watercraft

Carbon Ring Kit for Sea-Doo SPX 720

This carbon ring kit is a driveline sealing component for the 1996 Sea-Doo SPX 720 personal watercraft, sealing the driveshaft where it exits the hull to keep water out of the engine compartment.

Overview

This carbon ring kit provides the sealing components needed to service the driveshaft seal on a Sea-Doo SPX 720. The carbon ring kit is intended for owners and mechanics performing driveline maintenance on the 1996 SPX 720 model. A fresh carbon ring kit helps restore proper sealing and reduce water intrusion at the through-hull fitting.

Built For Performance

• Carbon sealing ring construction for a smooth, low-friction mating surface against the driveshaft
• Designed to fit the Sea-Doo SPX 720 from 1996
• Kit format supplies the ring and related seal components in one package
• Helps maintain a watertight seal at the driveshaft pass-through
• Direct-fit replacement for worn or damaged original sealing components

Fits These Machines

• for Sea-Doo SPX 720 1996

On-The-Job Use

• Routine driveline maintenance on personal watercraft
• Replacing a worn carbon seal that allows water into the hull
• Servicing the driveshaft seal during engine or pump removal
• Seasonal pre-ride inspections of the through-hull sealing area

Specs At A Glance

Good To Know

Q: How do I know if my carbon ring needs replacing? A: Common signs include water accumulating in the hull, a visible gap or wear on the ring face, or a damaged bellows. Inspect the sealing area whenever the driveshaft is accessible.

Q: Should the carbon ring be replaced alone or with other seals? A: It is often practical to replace related sealing components at the same time since the driveline must be opened up for access. Confirm which parts your model requires before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.