Carbon Ring Kit for Sea-Doo XP 800 1996

Carbon Ring Kit for Sea-Doo XP 800

This carbon ring kit is a driveshaft seal component for the 1996 Sea-Doo XP 800, built to help seal the hull pass-through where the driveshaft exits.

Overview

This carbon ring kit for Sea-Doo XP 800 supplies the sealing ring used at the driveshaft pass-through on the 1996 model. The carbon ring kit helps limit water entry into the engine compartment so the hull stays drier during use. It is intended for riders servicing the driveline on their Sea-Doo XP 800.

Built For Performance

• Carbon ring construction for a smooth sealing surface against the driveshaft
• Kit format supplies the ring and related sealing hardware for the seal assembly
• Designed for the 800 engine platform used in the 1996 XP
• Helps reduce water entry at the driveshaft pass-through
• Direct replacement style part for routine driveline service

Fits These Machines

• for Sea-Doo XP 800 (1996)

On-The-Job Use

• Driveshaft seal service on personal watercraft
• Routine driveline maintenance and rebuilds
• Hull pass-through repair when water intrusion is found
• Pre-season inspection and refresh

Specs At A Glance

Good To Know

Q: What does a carbon ring kit do on a personal watercraft? A: It provides the sealing ring at the driveshaft pass-through to help keep water out of the hull. It is a wear item that is commonly replaced during driveline service.

Q: Do I need any special tools to install this kit? A: Installation generally involves removing the driveshaft and seal housing to access the ring. Check your service manual for the correct procedure and torque values for your model.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.