Carbon Ring Kit for Sea-Doo XP 951 2000-2002

Carbon Ring Kit for Sea-Doo XP 951

This carbon ring kit is a driveshaft seal component for Sea-Doo XP 951 watercraft, designed to help keep water out of the hull where the driveshaft passes through.

Overview

This carbon ring kit for Sea-Doo XP 951 provides the sealing components used at the driveshaft pass-through on 2000 to 2002 models. The carbon ring kit helps limit water intrusion at the hull seal so the engine compartment stays drier during rides. It is intended for riders performing routine driveline maintenance on their Sea-Doo XP 951.

Built For Performance

• Carbon ring construction for a smooth sealing surface against the driveshaft
• Kit format supplies the ring and related sealing hardware for the seal assembly
• Designed to fit the 951 engine platform used in the XP from 2000 to 2002
• Helps reduce water entry at the driveshaft pass-through
• Direct replacement style part for routine driveline service

Fits These Machines

• for Sea-Doo XP 951 (2000)
• for Sea-Doo XP 951 (2001)
• for Sea-Doo XP 951 (2002)

On-The-Job Use

• Driveshaft seal service on personal watercraft
• Routine driveline maintenance and rebuilds
• Hull pass-through repair when water intrusion is found
• Pre-season inspection and refresh

Specs At A Glance

Good To Know

Q: What does a carbon ring kit do on a personal watercraft? A: It provides the sealing ring at the driveshaft pass-through to help keep water out of the hull. It is a wear item that is commonly replaced during driveline service.

Q: Do I need any special tools to install this kit? A: Installation generally involves removing the driveshaft and seal housing to access the ring. Check your service manual for the correct procedure and torque values for your model.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.