Carburetor Carb Rebuild Kit for Sea-Doo GTX 800 1996-1997

Carburetor Rebuild Kit for Sea-Doo

This carburetor rebuild kit for Sea-Doo restores fuel delivery on GTX 800 models from 1996 to 1997, replacing worn gaskets, seals, and internal carburetor components so the engine meters fuel correctly again.

Overview

This carburetor rebuild kit for Sea-Doo gives you the gaskets, seals, needles, and related internals needed to refresh a tired carb on GTX 800 watercraft. A clean, properly sealed carburetor restores smooth throttle response and reliable idle on the water. It is built for riders and mechanics rebuilding their own fuel system instead of replacing the whole carburetor.

Built For Performance

• Complete gasket and seal set for a full carburetor reseal
• Needle and seat components for consistent fuel metering
• Diaphragm and internal parts sized for the GTX 800 carburetor
• Materials chosen to resist fuel and marine moisture exposure
• Direct replacement fit for the listed model years

Fits These Machines

• for Sea-Doo GTX 800 1996
• for Sea-Doo GTX 800 1997

On-The-Job Use

• Rebuilding a carburetor that runs rich, lean, or floods
• Routine fuel system refresh during off-season maintenance
• Bringing a stored or non-running personal watercraft back into service

Specs At A Glance

Good To Know

Q: Do I need to remove the carburetor to install this kit? A: Yes, the carburetor should be removed and disassembled so the old gaskets and seals can be replaced with the new components in this kit.

Q: Should I check jetting after the rebuild? A: Yes, confirm jet sizes and settings match your model and altitude, then adjust the mixture screws as needed after reassembly.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.