Carburetor Fits WJ114 HS-314A HS314A Models TS700 TS800 Concrete Cut-Off Saws

Carburetor for TS700 TS800 Concrete Cut-Off Saws

This carburetor is a replacement fuel delivery unit for WJ114, HS-314A, HS314A, TS700 and TS800 concrete cut-off saws, metering fuel and air for steady cutting power.

Overview

This carburetor replaces the fuel mixer on WJ114, HS-314A, HS314A, TS700 and TS800 cut-off saws. It meters fuel and air to keep the engine pulling hard through concrete and masonry cuts. A practical fix for saws that bog, surge, or refuse to idle.

Built For Performance

• Direct replacement for WJ114, HS-314A and HS314A carburetor models
• Fits TS700 and TS800 concrete cut-off saw applications
• Integrated fuel pump diaphragm supports consistent fuel delivery at high RPM
• External adjustment screws allow idle and high-speed tuning
• Compact die-cast body mounts in the factory position

Fits These Machines

• WJ114 models
• HS-314A models
• HS314A models
• TS700 concrete cut-off saws
• TS800 concrete cut-off saws

On-The-Job Use

• Restoring hard-starting cut-off saws on concrete jobs
• Replacing worn or clogged carburetors after long service
• Keeping masonry and demolition saws running at full power

Specs At A Glance

Good To Know

Q: Should I tune the carburetor after installing it? A: Yes, most replacement carburetors need idle and high-speed screw adjustments once mounted. Start with the factory baseline settings and fine-tune on a warm engine.

Q: Will this fix a saw that only runs on choke? A: A saw that dies off choke often has a blocked or worn carburetor, and this replacement addresses that. Also check the fuel lines and filter for debris before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.