Carburetor for Kohler Courage 22 23 24 25 26 27 HP SV735 SV720 SV725 SV710 SV...

Carburetor for Kohler Courage Engines

This replacement carburetor is built to feed the correct air and fuel mixture on Kohler Courage 22 to 27 HP engine families, including SV710, SV720, SV725, SV735, and comparable SV-series motors.

Overview

This carburetor is a direct-fit fuel delivery component for Kohler Courage vertical and horizontal shaft engines in the 22 to 27 HP range. It meters fuel and air into the combustion chamber so the engine starts cleanly, idles evenly, and holds power under load. It is the right pick for equipment owners replacing a clogged, leaking, or worn carburetor on a Kohler Courage powered machine.

Built For Performance

• Precision metering jets and passages tuned for Kohler Courage 22 to 27 HP displacement ranges
• Die-cast body resists warping and seal failure under repeated heat cycles
• Integrated choke and throttle linkage points matched to factory style connections
• Fuel inlet and bowl design compatible with standard gravity and pump feed setups
• Gasket seating surfaces machined flat to reduce air leaks at the mounting flange

Fits These Machines

• for Kohler Courage SV710
• for Kohler Courage SV720
• for Kohler Courage SV725
• for Kohler Courage SV735
• for Kohler Courage 22 HP applications
• for Kohler Courage 23 HP applications
• for Kohler Courage 24 HP applications
• for Kohler Courage 25 HP applications
• for Kohler Courage 26 HP applications
• for Kohler Courage 27 HP applications

On-The-Job Use

• Riding mowers and lawn tractors running Kohler Courage engines
• Zero-turn mowers that rely on steady fuel delivery under load
• Small utility vehicles and garden tractors
• Seasonal equipment brought back into service after storage

Specs At A Glance

Good To Know

Q: Will this carburetor fit my Kohler Courage engine? A: It is intended for Kohler Courage SV-series engines in the 22 to 27 HP range such as the SV710, SV720, SV725, and SV735. Confirm your engine model and spec number before ordering.

Q: Do I need to adjust anything after installing it? A: Most installations need only idle and mixture tuning once the carburetor is mounted and the fuel lines are reconnected. Inspect the gaskets and linkage for wear during the swap.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.