Carburetor Gasket 46mm for Tiger Shark Daytona 640 1994-1995

Carburetor Gasket for Tiger Shark Daytona 640

This carburetor gasket is a 46mm sealing component designed to fit between the carburetor and intake on the Tiger Shark Daytona 640, helping prevent air leaks and fuel seepage for reliable engine performance.

Overview

This carburetor gasket serves the Tiger Shark Daytona 640 as a precision-fit seal at the carburetor mounting point. It is built to hold a tight seal under heat and vibration so the Daytona 640 carburetor delivers consistent air and fuel delivery. Ideal for riders and mechanics doing routine service or a rebuild.

Built For Performance

• 46mm sizing matched to the Daytona 640 carburetor bore
• Seals the carburetor-to-intake joint against air leaks
• Resists fuel, oil, and heat exposure under normal operation
• Helps maintain stable air and fuel mixture
• Direct-fit replacement for routine carburetor service

Fits These Machines

• for Tiger Shark Daytona 640 (1994-1995)

On-The-Job Use

• Carburetor rebuilds and reseal jobs
• Routine maintenance on the Daytona 640
• Fixing lean-running or air-leak symptoms
• Intake and fuel system service

Specs At A Glance

Good To Know

Q: How often should a carburetor gasket be replaced? A: Replace it whenever the carburetor is removed or if you notice air leaks, rough idle, or fuel seepage at the mounting joint.

Q: Does the gasket need any sealant? A: Most carburetor gaskets install dry, but always check your service manual for the specific Daytona 640 procedure.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.