Carburetor Gasket 46mm for Tiger Shark Monte Carlo 1000 1997

Carburetor Gasket for Tiger Shark Monte Carlo 1000

This 46mm carburetor gasket seals the carburetor mounting surface on the Tiger Shark Monte Carlo 1000, preventing air leaks that cause lean running and erratic idle.

Overview

The carburetor gasket for Tiger Shark Monte Carlo 1000 is a direct-fit sealing component for the 46mm carburetor setup. It sits between the carburetor and its mating surface to keep the air-fuel mixture consistent under load. This carburetor gasket suits riders servicing a 1997 Monte Carlo 1000 and anyone rebuilding a 46mm carburetor who wants a clean, reliable seal.

Built For Performance

• Cut to fit 46mm carburetor applications
• Seals the carburetor mounting surface against air leaks
• Helps maintain a stable air-fuel mixture
• Resists fuel and heat exposure in normal marine use
• Simple replacement item during carburetor service

Fits These Machines

• for Tiger Shark Monte Carlo 1000, 1997

On-The-Job Use

• Carburetor rebuilds and cleaning
• Intake sealing after removal of the carburetor
• Routine maintenance on a 1997 Monte Carlo 1000
• Fixing lean conditions traced to a leaking carburetor base gasket

Specs At A Glance

Good To Know

Q: Why replace the carburetor gasket? A: A worn gasket lets air into the intake, which leans out the mixture and causes poor running. Replacing it restores a proper seal at the carburetor mounting surface.

Q: Does this fit other 46mm carburetors? A: It is sized for 46mm carburetor applications and is listed for the Monte Carlo 1000. Confirm your carburetor size before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.