Carburetor Gasket 46mm for Tiger Shark Montego 640 1994-1997

Carburetor Gasket for Tiger Shark Montego 640

This 46mm carburetor gasket seals the mating surface on the Tiger Shark Montego 640, keeping air and fuel paths tight for consistent engine performance.

Overview

This carburetor gasket is a direct-fit sealing component for the Tiger Shark Montego 640 watercraft produced between 1994 and 1997. It sits between the carburetor and its mounting surface, preventing air leaks that can throw off fuel delivery. A smart pick for riders maintaining a personal watercraft with a 46mm carburetor setup.

Built For Performance

• 46mm sizing matched to the stock carburetor bore
• Seals the carburetor mounting surface against air leaks
• Helps maintain steady fuel and air delivery
• Suited to the 1994 through 1997 model range
• Compact gasket sized for straightforward installation

Fits These Machines

• for Tiger Shark Montego 640, 1994-1997

On-The-Job Use

• Carburetor reinstall after cleaning or rebuild
• Routine fuel system maintenance
• Resealing a leaking carburetor mount

Specs At A Glance

Good To Know

Q: Why replace a carburetor gasket? A: A worn or flattened gasket lets air leak past the mounting surface, which can disrupt the air and fuel mix. Replacing it restores a clean seal on the carburetor.

Q: Should the mounting surface be cleaned before fitting? A: Yes, remove old gasket residue and wipe the mating surfaces clean before installing the new gasket. This helps it seat evenly and seal properly.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.