Carburetor Gasket 46mm for Tiger Shark Montego DX 640 1994

Carburetor Gasket for Tiger Shark Montego DX 640

This 46mm carburetor gasket seals the carburetor mounting surface on the Tiger Shark Montego DX 640, preventing air leaks and fuel seepage for a consistent intake seal.

Overview

This 46mm carburetor gasket is made to seal the carburetor on a Tiger Shark Montego DX 640, keeping the fuel and air mixture contained at the mounting joint. A fresh carburetor gasket for the Tiger Shark Montego DX 640 helps restore a tight seal on older equipment where original gaskets have hardened or cracked. It suits owners of the 1994 Tiger Shark Montego DX 640 who need a dependable replacement during routine carburetor service.

Built For Performance

• 46mm sizing matches the carburetor bore used on the Montego DX 640
• Seals the carburetor mounting surface against air and fuel leaks
• Made from gasket material suited to fuel and heat exposure
• Direct replacement for a worn or compressed original gasket
• Simple install during carburetor removal or rebuild

Fits These Machines

• for Tiger Shark Montego DX 640 (1994)

On-The-Job Use

• Carburetor removal and reinstall
• Routine fuel system maintenance
• Rebuild or cleaning of the carburetor
• Restoring a proper intake seal on older equipment

Specs At A Glance

Good To Know

Q: How do I know if my carburetor gasket needs replacing? A: Signs include rough idling, air leaks at the mounting surface, or a visible crack or flattening on the old gasket. Replacing it during carburetor service is the simplest way to rule it out.

Q: Can I reuse the old gasket? A: Gaskets compress and harden over time, so a fresh one gives a more reliable seal than reusing a used gasket. Always fit a new gasket when the carburetor is removed.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.