Carburetor Gasket for Kawasaki SX 440 1977-1992 Rebuild Part

Carburetor Gasket for Kawasaki SX 440

This carburetor gasket is a sealing component that fits between the carburetor and its mounting surface on 1977 to 1992 Kawasaki SX 440 watercraft, preventing air and fuel leaks at the joint.

Overview

This carburetor gasket is built to seal the carburetor mounting surface on the Kawasaki SX 440 from 1977 through 1992. A fresh carburetor gasket keeps the joint airtight so the engine pulls the correct air and fuel mixture. It suits vintage PWC owners and mechanics servicing the fuel system.

Built For Performance

• Cut to match the carburetor mounting flange for a precise seal
• Fuel and oil resistant material stands up to constant gasoline contact
• Seals the mounting joint to prevent air leaks that cause lean running
• Withstands the heat and vibration of older two-stroke marine engines
• Direct replacement for a worn or hardened gasket on the SX 440

Fits These Machines

• for Kawasaki SX 440, 1977 to 1992 model years

On-The-Job Use

• Carburetor service and rebuilds on 1977 to 1992 Kawasaki SX 440 watercraft
• Fuel system repairs after the original gasket dries out or tears
• Routine tune-ups where the carburetor is removed and resealed
• Restoring a vintage watercraft that runs rough from a leaking carburetor base

Specs At A Glance

Good To Know

Q: How do I know if this gasket needs replacing? A: A hardened, cracked, or fuel soaked gasket can cause air leaks that make the engine idle poorly or run lean. Replacing it during carburetor service restores a proper seal.

Q: Can this gasket be reused after the carburetor is removed? A: Gaskets of this type are not designed to be reused once compressed and removed from the mounting surface. Fit a new one each time the carburetor is taken off.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.