Carburetor Gasket for Sea-Doo SPX 580 1993

Carburetor Gasket for Sea-Doo

This carburetor gasket is a sealing component that fits between carburetor mating surfaces to prevent air and fuel leaks on Sea-Doo SPX 580 watercraft from 1993.

Overview

This carburetor gasket is a direct-fit sealing part for the Sea-Doo SPX 580 produced in 1993. The carburetor gasket creates a tight seal between carburetor components, helping maintain proper air-fuel delivery and smooth engine operation. It is intended for riders and mechanics servicing or rebuilding the fuel system on these personal watercraft.

Built For Performance

• Precision-cut to match the carburetor mounting surface for a dependable seal
• Resists fuel, oil, and moisture for long-lasting service
• Helps prevent air leaks that cause lean running conditions
• Supports consistent fuel delivery for stable idling and acceleration
• Made from durable gasket material suited to marine engine environments

Fits These Machines

• for Sea-Doo SPX 580, 1993

On-The-Job Use

• Carburetor rebuilds and reseal jobs
• Routine fuel system maintenance
• Fixing vacuum or air leaks at the carburetor base
• Restoring smooth idle and throttle response

Specs At A Glance

Good To Know

Q: Does this gasket require any sealant during installation? A: In most cases a clean, dry fit is enough, but a thin fuel-resistant sealant can be used if the mating surface is slightly uneven. Always verify the mounting surface is free of old gasket material before installing.

Q: Can I reuse this gasket if I remove the carburetor again? A: Gaskets are typically single-use because they compress to form their seal, so replacing it is recommended any time the carburetor is removed. Reusing a compressed gasket can lead to air leaks.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.