Carburetor Repair Kit for Arctic Cat Bearcat 2000 570cc 2015-2018

Carburetor Repair Kit for Arctic Cat Bearcat 2000 / 570 cc

This aftermarket carburetor repair kit for Arctic Cat Bearcat 2000 and 570 cc models (2015-2018) supplies the gaskets, seals, and wear parts needed to rebuild a tired carb and restore smooth fuel delivery on the trail.

Overview

This carburetor repair kit is a full rebuild set for Arctic Cat Bearcat 2000 snowmobiles running the 570 cc engine built between 2015 and 2018. A worn carburetor repair kit is often the reason for rough idling, bogging, or hard cold starts, and rebuilding with fresh sealing components brings fuel metering back to spec. It is aimed at Bear Cat owners and small engine mechanics handling seasonal carb maintenance at home.

Built For Performance

• Includes carburetor gaskets sized for the stock 570 cc Bearcat intake setup
• Float bowl gasket seals the chamber against fuel seepage and air leaks
• Needle and seat components control fuel flow to prevent flooding
• Jet and adjustment sealing rings keep metering consistent across the throttle range
• Fuel resistant materials hold up to ethanol blended pump gasoline
• Direct replacement fit for the factory carburetor without machining or adapters

Fits These Machines

• for Arctic Cat Bearcat 2000, 2015
• for Arctic Cat Bearcat 2000, 2016
• for Arctic Cat Bearcat 2000, 2017
• for Arctic Cat Bearcat 2000, 2018
• for Arctic Cat 570 cc Bearcat models in the listed year range

On-The-Job Use

• Seasonal carburetor rebuilds before winter riding begins
• Fixing rough idle, hesitation, and off idle bog on trail machines
• Recovering a Bearcat that has been sitting with old fuel in the bowl
• Routine maintenance on utility and work snowmobiles covering long distances

Specs At A Glance

Good To Know

Q: Does this kit come with a new float? A: This is a repair kit for the carburetor and includes the sealing and wear items listed, not a complete replacement carburetor or float assembly. Retain the original float unless inspection shows damage.

Q: Can I install this without pulling the carburetor off the machine? A: The carburetor does need to be removed and opened to fit the gaskets and internals in this kit. Cleaning the passages and bowl while it is apart is strongly advised before reassembly.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.