Carburetor Repair Kit for Polaris Indy 500 2002

Carburetor Repair Kit for Polaris Indy 500

This carburetor repair kit for Polaris is a rebuild set that brings fuel metering back to spec on the Indy 500, replacing worn gaskets and seals so the engine idles cleanly and pulls hard.

Overview

This carburetor repair kit for Polaris supplies the wearable parts needed to rebuild a worn carb on the Indy 500. Fresh gaskets, seals, and metering components restore steady fuel delivery and dependable throttle response. It fits riders servicing their own 2002 Polaris Indy 500 before the season starts.

Built For Performance

• Gaskets and seals matched to the original carburetor body
• Float needle and seat components for consistent fuel level
• Fuel-resistant gasket material built for temperature swings
• Direct replacement for tired factory rebuild parts
• Complete set for a single carburetor rebuild

Fits These Machines

• for Polaris Indy 500, 2002

On-The-Job Use

• Rebuilding a carburetor after long storage
• Correcting rough idle and hesitation from hardened seals
• Seasonal carburetor service on a 2002 Polaris Indy 500
• Fuel system refresh before pre-season tuning

Specs At A Glance

Good To Know

Q: Is one kit enough for my machine? A: This kit covers a single carburetor rebuild, so order one kit for each carburetor on your sled. Q: Do I need to clean the carburetor before installing these parts? A: Yes, a thorough cleaning and inspection of the carburetor body is recommended before fitting the new components.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.