Carburetor Repair Kit for Ski-Doo MXZ 700 2000

Fork Seal and Wiper Set for Honda Shadow 500

This fork seal and wiper set is a direct replacement for the original seals on the Honda Shadow 500, restoring proper damping and keeping dust and debris out of the fork tubes.

Overview

This fork seal and wiper set is made for the Honda Shadow 500 VT500C and replaces worn or leaking front fork seals. A fresh fork seal and wiper set keeps oil where it belongs inside the fork and blocks grit from reaching the bushings. Riders and shops servicing the Shadow 500 will find this fork seal and wiper set a straightforward way to stop leaks and tighten front-end feel.

Built For Performance

• Seals and wiper rings supplied as a matched set for both fork legs.
• Seal lips shaped to hold fork oil under pressure during compression and rebound.
• Wiper rings scrape dust and road grit from the stanchion surface.
• Elastomer construction resists oil, ozone, and temperature swings.
• Direct fit into the stock fork seal bore with no machining needed.

Fits These Machines

• for Honda Shadow 500 VT500C 1985
• for Honda Shadow 500 VT500C 1986

On-The-Job Use

• Routine fork oil and seal service on the VT500C.
• Fixing oil weeping onto the fork tube and brake caliper area.
• Front-end rebuilds after a hard landing or fork tube replacement.
• Workshop maintenance before a riding season.

Specs At A Glance

Good To Know

Q: Do I need to drain the fork oil before fitting this set? A: Yes, the fork legs must be removed and drained before the old seals are pressed out and the new set is installed. Refill with the weight and volume specified for the VT500C.

Q: Does this set cover both fork legs? A: The seals and wipers are supplied for both legs so a single service can be completed in one sitting. Inspect the fork tubes for scratches while the seals are out.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.