Carburetor Repair Rebuild Kit For Honda XR 80 XR80 XR80R 1985-2003 Carb Kit New
Carburetor Repair Rebuild Kit For Honda XR 80 XR80 XR80R 1985-2003 Carb Kit New
Couldn't load pickup availability
Carburetor Repair Rebuild Kit for Honda XR 80 XR80 XR80R
This carburetor repair rebuild kit for Honda XR 80, XR80, and XR80R models from 1985 through 2003 supplies the gaskets and seals needed to reseal the carburetor and bring fuel metering back to spec.
Overview
This carburetor repair rebuild kit is made for the for Honda XR 80, XR80, and XR80R trail bikes built between 1985 and 2003. The kit refreshes the seals and gaskets inside the carburetor so it stops leaking and returns to smooth, predictable fueling. It suits riders and shops doing a carb kit service on an XR80 that has sat or run rough.
Built For Performance
- Rebuild kit covering the carburetor gaskets and seals
- Sized for the XR 80, XR80, and XR80R carburetor body
- Fuel-resistant construction for long service life
- Seals the carburetor against air and fuel leaks
- Helps restore clean idle and steady throttle response
- Direct-fit replacement for the original gasket set
Fits These Machines
- for Honda XR 80
- for Honda XR80
- for Honda XR80R
- for Honda XR80R models from 1985 through 2003
On-The-Job Use
- Carburetor service on a rough-running or hard-starting XR80
- Resealing a leaking carburetor during general maintenance
- Bringing a stored or neglected trail bike back into service
- Pre-season fuel system check on 1985 to 2003 XR 80 machines
- Bench rebuilds in a home garage or small shop
Specs At A Glance
| Part Number(s) | Carburetor Repair Rebuild Kit |
| Fitment Years | 1985 to 2003 |
| Compatible Models | for Honda XR 80, XR80, XR80R |
| Kit Type | Carburetor repair and rebuild set with gaskets and seals |
Good To Know
Q: Is this the same as a full carburetor replacement? A: No, this is a repair and rebuild kit that reseals your existing carburetor with fresh gaskets and seals instead of replacing the whole unit.
Q: Can I install this kit without removing the carburetor? A: Rebuilding a carburetor typically requires removing it from the bike, so plan on bench work to fit the gaskets and seals properly.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
