CBS1701 Turn Signal Windshield Wiper switch For 05-10 Chrysler 300 Dodge Charger

Turn Signal Windshield Wiper Switch for Chrysler/Dodge

This turn signal windshield wiper switch integrates signal and wiper controls, referencing OEM part number CBS1701 for 2005-2010 Chrysler 300 and Dodge Charger.

Overview

The turn signal windshield wiper switch replaces the multi-function stalk on 2005-2010 Chrysler 300 and Dodge Charger models, restoring accurate signaling and wiper operation. Designed for owners dealing with a worn or broken factory switch, this unit brings back self-canceling turn signals and reliable intermittent wiper delays. The turn signal windshield wiper switch uses factory-matched connectors and fits the original steering-column mounting without modification.

Built For Performance

• Plug-and-play harness connector matches the vehicle-side wiring for fast swap-out
• Self-canceling turn signal mechanism resets after cornering to avoid latent blinking
• Inspected and cleaned internal contacts for steady signal and wiper circuit continuity
• Wiper delay ring preserves the factory intermittent speed settings
• Stalk formed from impact-resistant material that withstands frequent rapid actuation

Fits These Machines

• for Chrysler 300 (2005-2010)
• for Dodge Charger (2005-2010)

On-The-Job Use

• Replacing a turn signal stalk that no longer cancels after the steering wheel returns
• Correcting erratic wiper function for safe commute driving in rain or snow
• Restoring headlight dimming and wash/wipe controls on daily-driver sedans
• DIY repair on fleet or family vehicles when the original multi-function switch fails
• Bringing back consistent hazard-light operation for roadside emergencies

Specs At A Glance

Good To Know

Q: Do I need to pull the steering wheel off to install this switch? A: Usually only the steering column shroud must be removed; a basic screwdriver and socket set will complete the swap while leaving the wheel in place.

Q: Will this combination switch work if my car has automatic rain-sensing wipers? A: This switch is designed for standard intermittent wipers; verify your vehicle’s wiper system before ordering if rain-sensing is present, as the connectors may differ.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.