Choke Cable for Polaris Indy XCR 700 1998

Choke Cable for Polaris Indy XCR 700

This choke cable is a replacement cable assembly that routes from the handlebar lever to the carburetor to actuate the choke for the Polaris Indy XCR 700, 1998.

Overview

This choke cable for Polaris Indy XCR 700 delivers dependable cold-start fuel enrichment by connecting the handlebar choke lever directly to the carburetor. Built as a direct-fit replacement, this Polaris Indy XCR 700 choke cable restores smooth lever action and consistent choke engagement. It suits riders performing routine maintenance or replacing a sticky, seized, or frayed cable on a 1998 Indy XCR 700.

Built For Performance

• Flexible inner cable engineered for smooth, low-effort lever travel
• Protective outer sheath resists abrasion, moisture, and cold-weather cracking
• Pre-formed end fittings for direct connection to the choke lever and carburetor
• Constructed from corrosion-resistant materials for long service life
• Correct cable length and routing for the 1998 Indy XCR 700 chassis

Fits These Machines

• for Polaris Indy XCR 700, 1998

On-The-Job Use

• Cold starts on trail rides and early-morning warm-ups
• Routine snowmobile maintenance and cable replacement
• Restoring proper choke actuation after a cable failure
• Seasonal tune-ups and pre-ride inspections

Specs At A Glance

Good To Know

Q: Will this cable fit my 1998 Indy XCR 700? A: It is offered specifically for the Polaris Indy XCR 700 for 1998, so confirm your model year and serial number before ordering.

Q: Does this replace the original cable? A: It is an aftermarket replacement that connects the handlebar choke lever to the carburetor. Routing and adjustment should follow your sled's service manual.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.