Choke Cable for Yamaha Grizzly 400 2007-2008 Models
Choke Cable for Yamaha Grizzly 400 2007-2008 Models
Couldn't load pickup availability
Choke Cable for Yamaha Grizzly 400
This choke cable is a direct replacement cable that operates the choke plunger on the carburetor, letting you richen the fuel mixture for cold starts on your Grizzly 400.
Overview
This choke cable is a fresh replacement for the worn or seized cable on your machine, restoring proper choke control at the handlebar. Built to match the original routing and length, this choke cable is an easy swap for a corroded or sticky unit. It suits riders who want reliable cold-start fuel enrichment without modifying their machine.
Built For Performance
- Correct length and routing for a direct fit on the Grizzly 400
- Flexible inner cable moves freely for smooth choke actuation
- Protective outer sheath guards against dirt and moisture
- Plated end fittings resist corrosion over repeated use
- Simple bolt-on replacement with no modification required
Fits These Machines
- for Yamaha Grizzly 400, 2007
- for Yamaha Grizzly 400, 2008
On-The-Job Use
- Cold morning starts when the engine needs a richer mixture
- Trail riding in cooler weather where choke control matters
- Replacing a sticky or snapped cable during routine maintenance
- Restoring factory choke function after a carburetor service
Specs At A Glance
| Compatibility | for Yamaha Grizzly 400, 2007-2008 |
| Type | Choke cable |
| Condition | New |
Good To Know
Q: Will this cable fit my 2007 or 2008 Grizzly 400? A: It is listed for the 2007-2008 Grizzly 400, but confirming your model and serial number before ordering is always wise. Q: Do I need to remove the carburetor to install it? A: On most machines the cable can be routed and connected with the carburetor in place, though access varies by setup.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
