Choke Cable Lever Kit for Polaris Starlite 250 1993-1995

Choke Cable Lever Kit for Polaris Starlite 250

This choke cable lever kit is a replacement control assembly that lets you actuate the choke directly from the handlebar area on your Polaris snowmobile.

Overview

The Choke Cable Lever Kit for Polaris Starlite 250 restores reliable cold-start control when your original lever or cable is stiff, broken, or missing. It gives you a clean, direct pull on the choke plunger so the engine enriches properly on startup. This choke cable lever kit is intended for owners of 1993 through 1995 Starlite 250 machines.

Built For Performance

• Lever and cable assembly engineered to match the Starlite handlebar layout
• Corrosion-resistant cable jacket protects the inner wire from moisture
• Smooth lever pivot action for consistent choke engagement
• Durable housing stands up to repeated pull cycles and cold weather
• Includes mounting hardware for straightforward installation

Fits These Machines

• for Polaris Starlite 250 (1993-1995)

On-The-Job Use

• Replacing a seized or snapped factory choke lever
• Restoring cold-start function on a classic Starlite 250
• Servicing the fuel enrichment system during seasonal tune-ups
• Getting a trail-ready sled back on the snow after a breakdown

Specs At A Glance

Good To Know

Q: Do I need to remove the carburetor to install this kit? A: In most cases you can route the new cable and swap the lever with the carb in place, though checking the choke plunger while you are there is worthwhile. Q: Is the cable pre-lubricated? A: The inner cable is treated for smooth operation, but a light application of cable lubricant before installation helps extend service life.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.