Clutch Cover Gasket for Honda CRF150R CRF150RB 2007-2024 CRF 150R 150RB

Clutch Cover Gasket for Honda CRF150R and CRF150RB

This clutch cover gasket for Honda CRF150R and CRF150RB seals the clutch cover to the engine case on 2007 through 2024 models, holding oil in and keeping the clutch side clean.

Overview

This clutch cover gasket for Honda CRF150R and CRF150RB is a replacement sealing component for the clutch cover mating surface. It prevents oil leaks and keeps dust and moisture out of the clutch area on 2007 to 2024 CRF 150R and CRF 150RB machines. Anyone servicing the clutch or resealing a weeping cover will find this clutch cover gasket a direct-fit option.

Built For Performance

• Shaped to match the factory clutch cover outline for a tight seal
• Withstands engine oil, heat cycles, and repeated cover removal
• Even compression across the gasket surface to stop seeps
• Replacement for stretched, torn, or hardened original gaskets
• Slim construction preserves stock cover fitment and clearances

Fits These Machines

• for Honda CRF150R 2007-2024
• for Honda CRF150RB 2007-2024
• for Honda CRF 150R
• for Honda CRF 150RB

On-The-Job Use

• Clutch cover removal and reinstall during clutch repair
• Sealing the cover after bearing or shaft service
• Refreshing gaskets on race and practice bikes
• Fixing oil weepage along the clutch cover edge

Specs At A Glance

Good To Know

Q: Is a new gasket needed each time the clutch cover comes off? A: Yes, the gasket compresses on installation and is not reusable, so fitting a fresh clutch cover gasket avoids leaks on reassembly.

Q: Can this gasket be installed without sealant? A: It is commonly installed dry on a clean, flat surface, though a small amount of gasket adhesive can help hold it in position during cover installation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.