Clutch Puller for Arctic Cat CFR8 CFR 8 Limited 2010-2011
Clutch Puller for Arctic Cat CFR8 CFR 8 Limited 2010-2011
Couldn't load pickup availability
Clutch Puller for Arctic Cat CFR8
This clutch puller removes the primary clutch on Arctic Cat CFR8 machines, giving you the tool needed to service or replace the clutch on 2010-2011 CFR 8 and Limited models.
Overview
This clutch puller is made for Arctic Cat CFR8 owners who need to pull the primary clutch for service or replacement. It threads into the clutch and lets you break the taper free using a wrench or impact driver. A solid addition to the toolbox for anyone maintaining a CFR 8 or Limited.
Built For Performance
- Hardened steel construction for repeat use
- Threaded end matches the primary clutch bore
- Center bolt design applies even force to break the taper
- Compact size fits standard tool kits
Fits These Machines
- for Arctic Cat CFR8
- for Arctic Cat CFR 8 Limited
- for Arctic Cat CFR8 2010-2011
On-The-Job Use
- Primary clutch removal during rebuilds
- Clutch spring and weight service
- Belt drive maintenance in the shop or trailer
Specs At A Glance
| Tool Type | Clutch puller |
| Compatibility | for Arctic Cat CFR8, CFR 8 Limited 2010-2011 |
| Material | Hardened steel |
Good To Know
Q: Do I need to grease the threads before use? A: A light coat of grease on the threads helps the puller seat smoothly and reduces wear. Wipe it clean after use to keep the threads sharp.
Q: Can this be used with an impact wrench? A: Yes, an impact wrench can help break a stubborn clutch taper. Apply steady pressure and make sure the puller is fully threaded in before you start.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
