Clutch Puller for Arctic Cat M800 2012-2013 M 800 HCR Sno-Pro

Clutch Puller for Arctic Cat M800

This clutch puller for Arctic Cat is a removal tool threaded to fit the primary clutch on M800, HCR, and Sno-Pro snowmobiles, letting you strip the clutch from the crankshaft safely.

Overview

This clutch puller for Arctic Cat is a purpose-built tool for removing the primary clutch from 2012-2013 M800, HCR, and Sno-Pro sleds. It threads into the clutch, then presses against the crankshaft end to release the taper fit without prying or hammering. A must-have for anyone doing their own clutch service or belt drive work.

Built For Performance

• Hardened steel body built to take high pull force
• Correct thread pitch for the M800 clutch hub
• Centering tip designed to press squarely on the crankshaft
• Solid one-piece construction with no swivel joints to fail
• Compatible with common hand tools for turning the puller
• Compact size that stores easily in a sled toolbox

Fits These Machines

• for Arctic Cat M800
• for Arctic Cat M 800 HCR
• for Arctic Cat M 800 Sno-Pro
• for Arctic Cat 2012 to 2013 M800 models

On-The-Job Use

• Pulling the primary clutch for spring or weight changes
• Clutch removal during engine or crank seal service
• Trailside or shop clutch repairs on M800 sleds
• Inspecting the clutch taper and crank snout for wear

Specs At A Glance

Good To Know

Q: Can the clutch be pulled without this tool? A: The clutch is mounted on a tapered shaft, so a puller is the safe way to release it without damaging the clutch or crankshaft.

Q: Does this puller work on other Arctic Cat models? A: It is intended for the M800 and the related HCR and Sno-Pro variants from the listed model years, so check your clutch thread before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.